1695609797768786.jpg

1. PTFE Film Tape

PTFE film tape 608CL is PTFE film coated with silicone adhesive. It will release from most resin systems.  They are ideal for use on tooling blocks and all areas where high elongation and release is needed. CG PTFE film tape 608CL will form to critical contours and mold surfaces while offering multiple releases or may be used to cover multiple detail mold seams. 

 

Advantages

• Provides semi-permanent release and superior surface finish, saving time and improving quality.
• Protect rubber tooling mandrels and intensifiers from resin attack, extending tool life and reducing cost.
• Good elongation makes application to complex shapes and details easier, reducing time and improving quality.

• Improve tool surface finish and aid resin flow for better part surface finish and reduced hand finishing.







 

 

1695609929191681.png

2. PTFE Coated Fiberglass Tape

PTFE Fiberglass Tape 918CL is PTFE coated fiberglass with silicone adhesive. It is designed to adhere to tool surfaces providing semi-permanent release and a reconditioned surface. It can be used on all types of molds, press platens, caul sheets or any surface that comes in contact with resins or adhesives. Release agents are not required on the mold surface thereby reducing cost and parts contamination.

 

Advantages

• Provides semi-permanent release and superior surface finish, saving time and improving quality.
• Protect rubber tooling mandrels and intensifiers from resin attack, extending tool life and reducing cost.

• Improve tool surface finish and aid resin flow for better part surface finish and reduced hand finishing.

 







1695610088616626.jpg

3. Release Fabrics

T6007 PTFE coated fiberglass fabrics will provide release from all conventional resin systems. Porous products will allow excess resin, volatiles and trapped air to escape into the breather during cure while non-porous products will retain resin. The release fabric have a continuous service temperature to 550°F (288°C).

 

Advantages

• Porous PTFE coating makes fabric much easier to remove off of cured laminates, resulting in time saved.
• Fiberglass retains its strength through high temperature use for easier removal after cure.






Send Inquiry→